This unit is a 110 volt single stage Love temperature controller which in installed in a quality plastic enclosure. The power cord is 14 gauge and is approximately 8′ in length. This controller is rated for 15 amps. The temperature probe is a PTC type sensor with a brass cap. The sensor cable is just over 4′ in length. The brass cap has been slightly sanded so it will fit inside a thermowell if needed. The temperature reading is in Fahrenheit “F”. This is a single stage unit which can be set to heat or cool.
The side of the unit has two standard 110 volt receptacles covered with an outdoor outlet cover. The power and sensor cable exit the enclosure by way of separate strain relief connectors.
This unit was being used to control the temperature of a freezer for fermentation and has been in service “on and off” for the last year. It has four exterior tabs on the enclosure for
mounting to the wall. It works great and is well built. I like this unit better than the Johnson Controls or Ranco because the display temperature display is large and bright.
I have also used this unit in heating mode to control a Fermwrap Carboy Heater. *This unit was not designed to power a RIMS tube heating element. You will most likely exceed the amp rating and damage the unit.
I am selling this unit for $124.00 plus $7.99 for shipping (USPS). If you are interested in purchasing this unit, email me at eric.knuds@gmail.com. We can arrange payment via Paypal. Guaranteed to not be dead on arrival.
Authors bio is coming up shortly. 