Like most brewers, I am interested on always finding a better way to do things. I own a Banjo burner along with several jet burners and have been tossing around my opinion of what really is a better burner. I have yet come to any conclussion. I have, however, reached an opinion on where the High Pressure Banjo burner might work better.

This test was done with the interest of boil in mind. I wanted to know how quick I could reach a boil after mash out.  I ran the test using a low pressure jet burner at .5 psi and a high pressure Banjo burner at 10 psi. Both propane burners were ran fully open and had their own propane source.

Two very similar stainless converted kegs (kettles) containing 6.5 gallons each were used.  I started this test at 166 on both kettles. Altitude for my testing location was around 980 feet.  I monitored the temperature of both kettles using a laptop, BCS460 , and two temperature probes.

When I made this video, I broke it into several  different segmants. Excuse the redundancy in advance!

Without spoiling the results from the video,  it is my opinion that the high pressure Banjo burner would make a great burner for your boil kettle or possibly your hot liquor tank. It is a little hot to be controlling your mash tun and takes adjusting if you want to reduce the heat.  After around twelve and a half minutes, the Banjo burner had the Jet burner by around seventeen degrees.

This Brewtus Ten was built completely from 2″x2″ steel square tubing based on Lonie’s original plans. Let’s face it, if we didn’t need it for brewing, we  could always use it as a car stand. This brew stand was built to last.

From left to right, our Brewtus Ten beer brewing system consists of a boil kettle, mash tun, and hot liquor tank. All three of which were created from modified kegs with tig welded fittings.

The boil kettle is quite simple. It consisted of a ball valve, dip tub, and a mash screen. I just toss whole hops into the boil and the mash screen filters them out.

The Mash Tun is the heart of this system. Inside the mash tun is a stainless steel false bottom. The outside bottom of the Mash Tun consists of a simple ball valve and thermometer.  The top portion of the Mash Tun consists of a stainless steel tee which accomodates a temperature probe. For more pictures of our Mash Tun, visit this link. Mash Tun

The Boil Kettle incorporates a ball valve, thermometer, and a port for a temperature probe. I created a custom welded bracket for a float switch. The float switch turns the pump off when the water reaches the predefinded water level.

I initially built the Brewtus Ten with two ASCO Valves. I was concerened with the pilot gas while using the ASCO Valve. If the pilot light burned out, the ASCO valve will still allow propane to flow. This was a safety issue to me. I changed the ASCO valves over to the Honeywell Gas Valves. This system uses a thermocouple. If the pilot fails, gas will not flow. This system is similar to how a gas water heater functions.

My system uses two March Brand magnetic pumps. If I could justify the extra money, I would purchase self priming pumps.

I started my control system using Love controls. The love controls worked well but I wanted more control and automation over the entire system. I wanted something that would control the pumps and provide me with more precise controls. I purchased a BCS-460 control system from Embedded Control Concepts.   The BCS-460 allows me complete control over the entire brewing process. Follow this link for more information on the BCS-460. BCS 460